Ceramic multi tube cyclone dust collector

Ceramic multi tube cyclone dust collector is suitable for capturing dry non fibrous granular dust. The main feature of ceramic multi tube cyclone dust collector is that the cylinder is inverted conical, which reduces the possibility of dust containing gas short circuiting from the cylinder to the outlet. The ceramic multi tube cyclone dust collector is equipped with a conical reflector screen to prevent two airflow streams from re rolling up the separated dust and being carried out by the upward airflow, thereby improving the dust removal efficiency.

Dust removal efficiency of ceramic multi tube cyclone dust collector:

The cyclone inside the ceramic multi tube cyclone dust collector is made of cast iron or ceramic, with a thickness greater than 6mm, thus having good performance. This dust collector is not only suitable for various boiler smoke and dust control, but also an ideal equipment for dust control in industries such as metallurgy, mining, building materials, and chemical industry.

The dust removal efficiency of the ceramic multi tube cyclone dust collector can reach above, and the resistance of the dust collector body is less than 900Pa. With the existing boiler induced draft fan, the boiler can operate normally. The XD-II ceramic multi tube cyclone dust collector has good load adaptability, and the dust removal efficiency is above 70% of the load.

The working principle of ceramic multi tube cyclone dust collector:

The dust concentration of gas has an impact on the efficiency and pressure loss of cyclone dust collectors. The experimental results show that the pressure loss when dealing with dusty gases is smaller than when dealing with clean air, and the pressure loss decreases with the increase of dust load. This is because a large number of dust particles in radial motion drag a large amount of air; When dust moves outward from a faster airflow to a slower airflow, it transfers energy to the outer layer of the rotating airflow, reducing its required pressure and thus reducing pressure loss. The dust removal efficiency of a cyclone dust collector increases with the increase of dust concentration. However, the speed of improving dust removal efficiency is much slower than the speed of increasing dust concentration. Therefore, it is necessary to continuously adjust the gas flow rate and speed according to the dust concentration of the gas, and always maintain a high dust removal rate. When selecting the capacity of dusty gases, in addition to concentration, the adhesion strength of dust should also be considered. When used for the purification of medium viscosity cohesive dust, the capacity of the dusty gas should be 1/4 of the allowable capacity. When used for the purification of high viscosity cohesive dust, the capacity of the dusty gas should be 1/8 of the allowable capacity, depending on the performance of the equipment.

The characteristics of ceramic multi tube cyclone dust collector:

1. Ceramic multi tube cyclone dust collector is suitable for dust control of industrial boilers and thermal power plant boilers of various models and combustion methods. Such as chain furnaces, reciprocating furnaces, fluidized bed furnaces, coal feeder furnaces, coal powder furnaces, cyclone furnaces, fluidized bed furnaces, etc.

2. For other industrial dust, this dust collector can also be used for treatment, and it can also be used for the recovery of cement and other practical dust.

3. Compared with electrostatic precipitators, the total investment is only 1/3 of electrostatic precipitators. Compared with water film precipitators, it does not require water treatment, avoids sewage discharge, and avoids secondary pollution. Except for fog dry dust collectors, this dust collector is an energy-saving type that does not require energy consumption.

4. The processing air volume is large, the load adaptability is strong, the ceramic movement is smooth, and there will be no blockage phenomenon. The footprint is small, and it can be flexibly installed according to the user's site conditions and local conditions. It can be placed indoors or outdoors. Easy to install, basically no maintenance required.